Solar PP Ballasted Ground Mount Bracket

1️⃣ Pallet Layout: Make sure the ground is flat, then put the pallets where they need to go based on your plan.

2️⃣ Counterweight Filling: Add 100–120 kg of gravel or stones to each pallet.

3️⃣ Tilt Angle Adjustment: Use shims to set the tilt angle between 0° and 15°.

4️⃣ Assembly and Clamping: Slide the clamps into the pallet slots, put the frame in place, and tighten the bolts to 10–15 Nm.

5️⃣ Grounding: Connect the grounding plate to the pallet or grounding point, following local rules.

6️⃣ Final Inspection: Check the weight, bolt tightness, and clamp positions. Keep a record of everything and check it again every six months.

☆ Easy to install with plastic ballast pan and end clamps.

☆ Can be set up in different ways depending on your site.

☆ Works on any flat surface without causing damage.

Q1. Is there any wind speed and snow load test?

Yes.

Q2. Is there any certification?

Yes.

Q3: Could the tilt angle be changed? Like reduced to 15°?

The mold is fixed 18°. 

New mold need to be opened for other angle. The cost is too high to open for small qty. 

Q4: Is the PP mount have request on solar panel size?

For panel put in horizontal, the panel width should be 992-1010mm. Other panel width need to get a adapter. 

For panel put in vertical, no request.

Q5: Does the price for the item comprehensive of clamps and any other material needed to mount the system? 

Yes, The price included the clamps to mount panels, which is complete, except for the ballast gravel.

Q6: What will be excluded from the final DDU quotation (ex. customs clearance / european due taxes)?

With DDU terms, only the import taxes and VAT are not included, 6.5% for european countries.